NISSAN MICRA (K11) CIRCUIT DIAGRAM — Centre (Base trim Foldout)
EL-NC-ELECTRICAL-002wiring diagramBASE K11 master CIRCUIT DIAGRAM centre. ECCS 48-pin. Driving lamp + Headlamp wiper as base-K11-specific features (dropped on later supplements). Two wiper switch variants (INT vs 2-SPEED).
NISSAN MICRA (K11) CIRCUIT DIAGRAM — Centre (Base trim)
NOTE
Centre band of base K11 CIRCUIT DIAGRAM. Three sub-bands document:
• Top: ECCS sensors and actuators — Crank Angle Sensor, Air Flow Meter, Throttle Sensor, Engine Temperature Sensor, Fuel Pump. E.C.C.S. CONTROL UNIT 48-pin numeric scheme. Distributor + 4 spark plugs via Power Transistor + Ignition Coil.
• Middle: Lighting in 'Without daytime and dim-dip lamp systems' variant (the non-DRL/non-dim-dip base trim). Adds DRIVING LAMP relay + lamps (auxiliary forward lamps, separate from fog).
• Bottom: Wipers — TWO variants of front wiper/washer switch (With intermittent vs 2-SPEED). Rear wiper. HEADLAMP WIPER (LH+RH) with dedicated amp — base K11 feature later dropped.
Key architectural divergences vs Supplement-VI/VII:
• Single crank angle sensor (not POS + PHASE pair)
• Air flow meter without integrated IAT
• DRIVING LAMP as separate circuit (Supplement-VI/VII drop)
• HEADLAMP WIPER (Supplement-VI/VII drop in favour of headlamp washer-only)
• Two wiper-switch variants (Supplement-VI/VII unify to single switch with MIST/INT/LOW/HI)
WARNING
Base K11 has DRIVING LAMP feature (separate from fog lamp) — a forward auxiliary lamp. Don't confuse with front fog lamp circuit. Also note: HEADLAMP WIPER (with dedicated amp) is base-K11-specific and dropped on later supplements.