STARTING SYSTEM — Wiring Diagram (Cont'd) — Starting System Trouble-Shooting (Base K11)
EL-25flowchartUnverifiedBase K11 STARTING SYSTEM trouble-shooting flowchart (sideways/rotated 90° CCW). Diagnostic tree: engine-no-start → crank? → motor turn? → battery/inhibitor/magnetic-switch/meshing checks → no-load bench test (SEL312B). Inhibitor-relay step applies to CVT only.
Wiring Diagram (Cont'd)
STARTING SYSTEM TROUBLE-SHOOTING
Starting system trouble-shooting (engine does not start)
1
Engine does not start.
2
Does engine turn by cranking?
Yes
Does engine turn normally?
No
3
Does starter motor turn?
Yes
Does gear shaft turn?
No
4
Check battery for charging condition and battery terminals for connections and corrosion.
N.G.
[N.G.] Charge or replace battery. Repair connections and corrosion of battery terminals.
O.K.
5
Can you hear inhibitor relay operating? (inhibitor relay equipped model only)
No
[No] Check and repair wiring system of: ignition switch, inhibitor relay, harness and terminal connections.
Yes
6
Can you hear magnetic switch of starter motor operating?
No
[No] Check and repair wiring up to magnetic switch. Repair or replace magnetic switch.
Yes
7
Is meshing condition of pinion and ring gear O.K.?
N.G.
[N.G.] Adjust dimension ℓ. Check shift lever for deformation, return spring for fatigue and pinion for sliding condition. Correct meshing condition of pinion and ring gear. Replace if necessary.
[N.G.] Adjust dimension ℓ. Check shift lever for deformation, return spring for fatigue and pinion for sliding condition. Correct meshing condition of pinion and ring gear. Replace if necessary.
O.K.
8
Remove starter motor from engine. Does starter motor turn under no load by connecting battery (+) terminal to M terminal of starter motor and battery (-) terminal to starter motor body?
No
[No] Check armature assembly, field coil and brush. Replace if necessary.
N.G. (Turns slowly)
[N.G. (Turns slowly)] Check battery for charging condition and battery terminals for connections and corrosion. → If N.G.: Repair or replace starter motor. → If O.K.: Repair or replace starter motor.
[N.G. (Turns slowly)] Check battery for charging condition and battery terminals for connections and corrosion. → If N.G.: Repair or replace starter motor. → If O.K.: Repair or replace starter motor.
Yes
9
Check magnetic switch contacts. Replace if necessary.
WARNING
If any abnormality is found, immediately disconnect battery negative terminal.
NOTE
Page printed sideways (rotated 90° CCW) in the raster — read bottom-to-top, left-to-right. Standard starting-system diagnostic tree: from 'engine does not start', branches on whether the engine cranks, whether the starter motor/gear turns, and proceeds through battery → inhibitor relay → magnetic switch → pinion meshing → no-load bench test. Final-column boxes are the corrective actions (Problem or corrective action / Check item legend at top-right).