WIPERS AND WASHERS — Rear Wiper and Washer / Wiring Diagram — L.H.D. Model
EL-102wiring diagramCommon K11 fault: rear wiper relay or back-door harness flex break — opens the wiper feed without affecting the washer. Diagnose at the relay output (LG/R should pulse when stalk is in WIPE).
L.H.D. Model
NOTE
Rear wiper is single-speed, relay-controlled. Switch is part of the combination stalk, on a separate 4-pin sub-connector. Same washer-fluid reservoir as the front (shared in engine bay).
Wiring Schematic
Components (9)
Connections (9)
BAT
BATFB10ABattery feed
IGN
IGNFB10AIgnition feed
FB10A
FB10ARELBlue — relay common
RSW
RSWRELLight Green with Red — relay coil drive
RSWWASHLight Green with Black — washer-motor feed
REL
RELRMOTLight Green with Red — wiper-motor feed via back-door harness
RELGND_METERBlack — relay coil ground
RMOT
RMOTGND_REARBlack — rear wiper motor ground
WASH
WASHGND_METERBlack — rear washer motor ground