HEADLAMP — Without Daytime Light System and Dim-dip Lamp System — Wiring Diagram
EL-42wiring diagramUnverifiedBaseline two-filament headlamp circuit, no relays — switched current flows direct from the lighting switch / dip-main stalk to the bulbs (no headlamp relay shown). This is the export-market baseline; DRL and dim-dip variants are documented separately later in the section.
Wiring Diagram
NOTE
Baseline (non-DRL, non-dim-dip) headlamp circuit. Both headlamps fed from a pair of 5A fuses in the fusible-link box; routing is via the engine-room L.H. / R.H. harnesses and crosses to the main harness through S.M.J. cells F11/F12/F13. High beam is tapped (R/W) to the combination-meter HIGH BEAM tell-tale.
Wiring Schematic
Components (12)
Connections (14)
BAT
BATFLBOXWhite with Green stripe — fusible-link feed
FLBOX
FLBOXLSWHeadlamp supply — through 5A fuses to lighting switch (color not legible at 900×1850)
LSW
LSWCSWRed — common rail to dip/main combination switch
CSW
CSWHRHRed with Green stripe — high beam to RH headlamp
CSWHRHRed with Blue stripe — low beam to RH headlamp
CSWSMJRed with Black — cell F12
CSWSMJRed with Yellow — cell F11
CSWSMJRed with White — cell F13
SMJ
SMJHLHRed with Black — high beam to LH headlamp
SMJHLHRed with Yellow — low beam to LH headlamp
SMJMETERRed with White — high-beam tell-tale tap
METER
METERGND_METERBlack — meter ground
HRH
HRHGND_RHBlack — RH headlamp ground
HLH
HLHGND_LHBlack — LH headlamp ground
See also
Foldout page (S.M.J.)