HEADLAMP — Bulb Replacement (Cont'd) + Disassembly (Base K11)
EL-57prose procedureBase K11 HEADLAMP — bulb replacement cont'd (caution: don't leave reflector open, pull H4 only just before refit; connector terminal map UEL053) + disassembly (release perimeter lens retaining clips for lens/reflector replacement, UEL054).
Bulb Replacement (Cont'd)
CAUTION
• Do not leave the bulbs out of the headlamp reflectors for long periods of time; particles of dust, moisture, smoke etc. may enter the headlamp enclosure and affect the performance of the lamps. In particular, the H4 main/dipped beam bulb should not be removed from the headlamp reflector until just before a replacement bulb is to be installed.
DISASSEMBLY
The headlamp can be disassembled for lens/reflector replacement.
To remove headlamp lens release lens retaining clips.
NOTE
Bulb-out caution: don't leave the reflector open — dust/moisture/smoke ingress degrades the lamp; only pull the H4 bulb just before fitting its replacement. The connector terminal map (UEL053) identifies H4 main/low/earth, turn-signal +ve/earth, and clearance +ve pins. The headlamp is dismantlable for lens/reflector service by releasing the perimeter lens retaining clips (UEL054).