EXTERIOR LAMPS — Clearance, License, Tail and Stop Lamps / Wiring Diagram — L.H.D. Model Without Daytime Running Lamps
EL-61wiring diagramLHD non-DRL is the baseline that other rear-lamp variants extend (DRL adds the DRL control unit between the lighting switch and clearance/tail; RHD swaps clearance harness sides). The license-plate-lamp ground rides on the rear body grounds via the back-door harness — a hatch-closed open will kill the license-plate-lamp ground without killing the rear-lamp grounds.
L.H.D. Model — Without Daytime Running Lamps
NOTE
(Page rendered with text running bottom-to-top — original landscape layout.) Standard LHD non-DRL rear-lamp wiring: TAIL bus (R/L) drives clearance + license + rear-tail; STOP signal (R/G) from the brake-pedal switch drives both rear combination STOP filaments. Stop and clearance circuits share the same 12V fused supply but are separately switched.
Wiring Schematic
Components (15)
Connections (16)
BAT
BATFLBOXWhite — heavy-gauge supply
FLBOX
FLBOXFB10AWhite with Red — fused 10A feeds
FB10A
FB10ASLSWhite with Red — stop-lamp switch supply
FB10ALSWWhite with Black — TAIL bus into lighting switch
LSW
LSWREAR_RHRed with Blue — TAIL feed to RH tail filament
LSWREAR_LHRed with Blue — TAIL feed to LH tail filament
LSWLICRed with Blue — license plate lamp
LSWCLR_RHRed with Blue — RH clearance
LSWCLR_LHOrange — LH clearance
SLS
SLSREAR_RHRed with Green — RH stop filament
SLSREAR_LHRed with Green — LH stop filament
REAR_RH
REAR_RHGND_REARBlack — RH rear lamp ground
REAR_LH
REAR_LHGND_REARBlack — LH rear lamp ground
LIC
LICGND_REARBlack — license-plate-lamp ground (back-door)
CLR_RH
CLR_RHGND_RHBlack — RH clearance ground
CLR_LH
CLR_LHGND_LHBlack — LH clearance ground
See also
Foldout page (S.M.J.) · POWER SUPPLY ROUTING