EXTERIOR LAMPS — Clearance, License, Tail and Stop Lamps / Wiring Diagram (Cont'd) — R.H.D. Model
EL-63wiring diagramSame RHD page has to cover four variants (rear-wipers Y/N × SMJ Y/N) — fewer dedicated pages than usual. The wiper variants don't affect tail-lamp routing directly; they're flagged because the body harness No. 2 inlines pass close to the wiper-motor connector. SMJ variant differs in whether the lighting-switch output uses inline connectors or S.M.J. cell A9 to cross the main↔engine-room boundary.
R.H.D. Model
NOTE
(Page rendered with text running bottom-to-top — original landscape layout.) Variant markers on this page:
• W = Vehicles with rear wipers
• W̄ (W with overbar) = Vehicles without rear wiper
• M/T = Manual transaxle without S.M.J.
• N·CVT = N·CVT transaxle and manual transaxle with S.M.J.
All four variants share the same lamp fixtures and stop-switch wiring; only the inline connectors and S.M.J. cell paths differ.
Wiring Schematic
Components (15)
Connections (16)
BAT
BATFLBOXWhite with Red — heavy gauge
FLBOX
FLBOXFB10AWhite with Red — fused supply
FB10A
FB10ALSWGreen with Red — TAIL bus into lighting switch
FB10ASLSRed with Yellow — stop-switch supply
LSW
LSWREAR_RHRed with Blue — TAIL feed to RH
LSWREAR_LHRed with Blue — TAIL feed to LH
LSWLICRed with Blue — license plate
LSWCLR_RHRed with Blue — RH clearance
LSWCLR_LHRed with Blue — LH clearance
SLS
SLSREAR_RHRed with Green — RH stop
SLSREAR_LHRed with Green — LH stop
REAR_RH
REAR_RHGND_REARBlack — RH rear ground
REAR_LH
REAR_LHGND_REARBlack — LH rear ground
LIC
LICGND_REARBlack — license-plate ground
CLR_RH
CLR_RHGND_RHBlack — RH clearance ground
CLR_LH
CLR_LHGND_LHBlack — LH clearance ground
See also
Foldout page (S.M.J.)