INTERIOR LAMPS — Illumination / Wiring Diagram — With Daytime Light System
EL-7029wiring diagramDaytime Light System variant routes the illumination bus through the DTL control unit; non-DTL variants (other pages) wire the bus straight to the switches.
Illumination / Wiring Diagram
With Daytime Light System
NOTE
Panel-illumination distribution: ignition switch ON or START feeds the 10A fuse [8] and fuse-block (3W trace) downstream of the master lighting switch. With the lighting switch in 1ST or 2ND, the R/L (illumination supply) and R/W (dimmer return) lines are energized and reach the sport-mode switch, heater control panel, hazard switch, audio unit, rear-window defogger switch, combination meter (pins 1 and 15) and the daytime-light control unit.
Wiring Schematic
Components (14)
Connections (17)
BAT
BATFLWhite
FL
FLFUSE_8Green with Red stripe
IGN
IGNFUSE_BLOCK??
FUSE_8
FUSE_8LIGHT_SWReference label — 3W gauge
LIGHT_SW
LIGHT_SWSPORT_SWRed with Blue stripe
LIGHT_SWHEATERRed with Blue stripe
LIGHT_SWHAZARDRed with Blue stripe
LIGHT_SWAUDIORed with Blue stripe
LIGHT_SWDEFOGRed with Blue stripe
LIGHT_SWMETERRed with Blue stripe
LIGHT_SWDTL_CURed with Blue stripe
SPORT_SW
SPORT_SWGNDBlack
HEATER
HEATERGNDBlack
HAZARD
HAZARDGNDBlack
AUDIO
AUDIOGNDBlack
DEFOG
DEFOGGNDBlack
METER
METERGNDBlack
NOTE
Legend: C = With CVT (sport-mode switch only present on CVT), AU = With audio system (audio-unit illumination branch). The presence of the daytime-light control unit on the illumination bus means panel-illumination is gated by the DTL unit on cars that have it — e.g. dimmed differently when daytime running lamps are active.
See also
EL — POWER SUPPLY ROUTING