WIPERS AND WASHERS — Front Wiper and Washer — Wiring Diagram — L.H.D. Model (Base trim)
EL-1036wiring diagramBASE K11 LHD front wiper. Single 20A fuse (Supplement-VII later split). No MIST mode. Same amplifier-based INT mode architecture as later supplements.
Front Wiper and Washer / Wiring Diagram
L.H.D. Model — Base K11 trim
13
FunctionAuto Stop
OFF○
INT
LOW
HIGH
WASH
14
FunctionLow
OFF○
INT○
LOW○
HIGH
WASH
15
FunctionAmp
OFF
INT○
LOW
HIGH
WASH
16
FunctionHi
OFF
INT
LOW
HIGH○
WASH
17
FunctionEarth
OFF
INT
LOW
HIGH
WASH
18
FunctionWash
OFF
INT
LOW
HIGH
WASH○
NOTE
Base K11 LHD front wiper wiring. Single 20A fuse protects wiper motor + washer pump (Supplement-VII later separates these). WIPER AMPLIFIER is a separate module providing INT-mode timing. No MIST mode on base trim (added in Supplement-VI).
WIPER/WASHER SWITCH is a 6-pin block (pins 13-18). Pin 14 (Low) closes in INT and LOW positions — INT mode uses the amp to pulse this. Pin 16 (Hi) closes only in HIGH. Pin 18 (Wash) closes only in WASH.
Variant tag A = with-ABS — only effect is harness routing changes (ABS sensor connectors share the engine-room harness).
WARNING
BASE K11 has NO MIST mode. Supplement-VI added MIST. Don't expect a momentary single-wipe on base trim — only INT/LOW/HIGH/WASH.