HEADLAMP — Headlamp Aiming Control — Wiring Diagram (Cont'd) — Without Daytime Light System (Supplement-VII)
EL-7020wiring diagramNon-DRL aim-control wiring. Direct ignition-to-switch path, no DRL CU. LHD uses connector C56, RHD uses M40 for the fuse-block-output cell 3W feed.
Wiring Diagram (Cont'd) — Without Daytime Light System
NOTE
Non-DRL pendant of EL-7019. No DRL CU in the path — aim switch is supplied directly from ignition through fuse-block CONNECTOR C56 (LHD) / M40 (RHD) cell 3W (P wire). CONNECTOR M139 cell 11Y supplies battery to the resistor-ladder upper rail (R/L wire). The rest of the circuit is identical to the DRL variant: 4-position slide switch + resistor ladder + parallel drive to both AIMING MOTOR UNITs.
Variant legend on this page:
• L LHD / R RHD — connector ID differs (C56 vs M40)
• GS gasoline / DI diesel — fuse-box battery-side pin differs (E27 vs E71)
WARNING
If a vehicle that lacks DRL has aim-switch faults, this is the schematic to use — DO NOT cross-reference EL-7019. The DRL CU is absent; the failure modes are simpler (no gating logic in the path).