EXTERIOR LAMPS — Turn Signal and Hazard Warning Lamps / Wiring Diagram
EL-7025wiring diagramHazard branch is battery-fed (works with ignition off); turn branch is ignition-fed. Combination flasher unit drives both — hazard switch on bridges left+right inputs in parallel.
Turn Signal and Hazard Warning Lamps / Wiring Diagram
NOTE
Turn signal: ignition switch (ON or START) → 10A fuse [11] → combination flasher unit → turn-signal switch → left or right output to the front turn signal lamps, side turn signal lamps, rear combination lamp TURN filaments and the dashboard indicator (combination meter pins 5 and 1, 25).
Hazard: battery → 10A fuse [15] → hazard switch (ON position) → both left and right outputs simultaneously via the combination flasher unit.
Wiring Schematic
Components (15)
Connections (20)
BAT
BATFUSE_15??
IGN
IGNFUSE_11??
FUSE_15
FUSE_15HAZARD_SWGreen with Orange stripe
FUSE_11
FUSE_11FLASHERGreen
FLASHER
FLASHERHAZARD_SWLight Green with Black stripe
HAZARD_SW
HAZARD_SWTURN_SWLight Green with Black stripe
TURN_SW
TURN_SWFRONT_RHGreen with Yellow stripe (RH)
TURN_SWREAR_RHGreen with Yellow stripe (RH)
TURN_SWSIDE_RHGreen with Yellow stripe (RH)
TURN_SWFRONT_LHGreen with Black stripe (LH)
TURN_SWREAR_LHGreen with Black stripe (LH)
TURN_SWSIDE_LHGreen with Black stripe (LH)
TURN_SWMETERGreen with Yellow stripe (RH)
TURN_SWMETERGreen with Black stripe (LH)
FRONT_RH
FRONT_RHGNDBlack
FRONT_LH
FRONT_LHGNDBlack
REAR_RH
REAR_RHGNDBlack
REAR_LH
REAR_LHGNDBlack
SIDE_RH
SIDE_RHGNDBlack
SIDE_LH
SIDE_LHGNDBlack
NOTE
Variant markers: L = LHD, R = RHD. The 'To illumination system' branch is the panel-illumination tap used by the meter dimmer circuit.
See also
EL — POWER SUPPLY ROUTING