HEADLAMP - Aiming Adjustment
EL-7017prose procedureAiming Adjustment
NOTE
For details, refer to the regulations in your own country. Before performing aiming adjustment, check the following.
- 1Keep all tires inflated to correct pressures.
- 2Place vehicle on flat surface.
- 3See that there is no-load in vehicle (coolant, engine oil filled up to correct level and full fuel tank) other than the driver (or equivalent weight placed in driver's position).
CAUTION
Be sure aiming switch is set to "0" when performing aiming adjustment on vehicles equipped with headlamp aiming control.
LOW BEAM
- 1Turn headlamp low beam on.
- 2Use adjusting screws to perform aiming adjustment.
- 3First tighten the adjusting screw all the way and then make adjustment by loosening the screw.
- 4Adjust headlamps so that main axis of light is parallel to center line of body and is aligned with point P shown in illustration.
- 5Figure to the left shows headlamp aiming pattern for driving on right of road; for driving on left side of road, aiming pattern is reversed.
- 6Dotted lines to point P in illustration show center of headlamp.
| Specification | Value |
|---|---|
| H | Horizontal center line of headlamps |
| W_L | Distance between each headlamp center |
| L | 5,000mm (196.85 in) |
| C | 60mm (2.36 in) |
H
Horizontal center line of headlamps
W_L
Distance between each headlamp center
L
5,000mm (196.85 in)
C
60mm (2.36 in)