METER AND GAUGES — Combination Meter
EL-84wiring diagramUnverified30-pin combination meter (slightly trimmed from the 32-pin version on Supplement-II) — same pin numbering convention. Speed sensor on pin 11 is the gearbox VSS feed; pin 30 'N·CVT' is the CVT range-position signal used to gate the position indicator.
NOTE
Two-page reference: this page shows the combination meter's front (visible side), back (PCB layout) and internal circuit (pins → loads). The single Diode prevents feedback between the warning rails; the Resistor dims the digital clock illumination. The 30-pin total is split across three connector blocks (pins 1-12 / 13-18 / 19-30).
1
FunctionFuel gauge
2
FunctionTachometer
3
Function—
4
FunctionClock
6
FunctionCharge warning
7
FunctionOil warning
11
FunctionSpeed sensor
12
FunctionBrake warning
13
FunctionGround
14
FunctionHigh beam tell-tale
15
Function—
16
FunctionTurn L.H.
17
FunctionTurn R.H.
19
FunctionFuel warning
22
FunctionInstrument illumination
24
FunctionBattery +12V
25
FunctionTachometer signal
26
FunctionWater temp gauge
27
FunctionABS warning
30
FunctionN·CVT signal
Parts Diagram
Diagram image not available