WARNING LAMPS AND BUZZERS — Warning Buzzer / Wiring Diagram (Cont'd) — L.H.D. Model (N·CVT)
EL-97wiring diagramUnverifiedInhibitor-switch dot-matrix not all OCR-legible at 900×1850; captured topology + obvious pole closures. Full dot pattern on next page may need cross-reference.
L.H.D. Model (N·CVT)
NOTE
N·CVT cars get a separate buzzer wiring diagram because the buzzer's 'Key-in-IGN' logic gates on the inhibitor switch's IGN SW + Range SW-P pole (so it doesn't sound when CVT is in P with the key in). The buzzer module is fed by IGNITION RELAY-3 the same way as M/T, but the door-open signal is gated by the N·CVT control unit.
Inhibitor switch truth table
IGN SW
P○
R
N○
D
D2
Range SW-P
P○
R
N
D
D2
Range SW-N
P
R
N○
D
D2
Range SW-D
P
R
N
D○
D2
Range SW-D2
P
R
N
D
D2○
IGN ST SW
P○
R
N○
D
D2
ST MTR
P○
R
N○
D
D2
NOTE
Captured truth table from inhibitor switch — same multi-pole switch used by the starting circuit (EL-24) is reused here for the buzzer + range-indicator logic. (Some D/D2 columns not legible on the dot matrix at thumbnail resolution; reported the best-read column pattern.)