STARTING SYSTEM — Starter — Assembly + Service Data and Specifications (Base K11)
EL-32spec tableBase K11 STARTING SYSTEM — Starter SDS table (0.9/1.1 kW). Commutator min dia 28.8mm, brush min length 5mm, spring tension 14.3-25.2N, pinion clearance 0-0.45 M/T / 0-0.6 CVT. Assembly = reverse of disassembly + high-temp grease.
Starter Motor — Assembly —
Assembly is the reverse process to disassembly.
CAUTION
• Apply high-temperature grease to lubricate the bearing, gears and pinion shaft when assembling the starter.
Service Data and Specifications (S.D.S.)
STARTER
Rating (kW)
0.9 kW0.9
1.1 kW1.1
System voltage (V)
0.9 kW12
1.1 kW12
No-load voltage (V)
0.9 kW11.5
1.1 kW11
Current maximum (A)
0.9 kW50
1.1 kW75
Revolution (rpm)
0.9 kW4900
1.1 kW2700
Minimum diameter of commutator mm (in)
0.9 kW28.8 (1.134)
1.1 kW28.8 (1.134)
Minimum length of brushes mm (in)
0.9 kW5 (0.2)
1.1 kW5 (0.2)
Brush spring tension N (kg, lb)
0.9 kW14.3 - 25.2 (1.46 - 2.57, 3.22 - 5.67)
1.1 kW14.3 - 25.2 (1.46 - 2.57, 3.22 - 5.62)
Clearance 'ℓ' between pinion front edge and pinion stopper (mm)
0.9 kW0 - 0.45 M/T / 0 - 0.6 N·CVT
1.1 kW0 - 0.45 M/T / 0 - 0.6 N·CVT
NOTE
Starter SDS for both 0.9 kW and 1.1 kW units. Key wear limits: commutator min diameter 28.8 mm (1.134 in), brush min length 5 mm (0.2 in), brush spring tension 14.3-25.2 N. Pinion clearance 'ℓ': 0-0.45 mm for M/T, 0-0.6 mm for N·CVT (the gap measured on EL-31). No-load: 0.9 kW = 50 A max at 4900 rpm (11.5 V); 1.1 kW = 75 A max at 2700 rpm (11 V). Apply high-temp grease at assembly.