EXTERIOR LAMPS — Turn Signal and Hazard Warning Lamps / Wiring Diagram — L.H.D. Model
EL-73wiring diagramHazards work with ignition OFF (independent fuse direct to battery); turn signals only with ignition ON. Combination flasher unit replaces the older separate flasher relay + hazard relay. Wire colour codes on this page mix G/Y (RH side) and G/B (LH side) — useful diagnostic shorthand.
L.H.D. Model
NOTE
K11 uses a single combination flasher unit for both turn signals (ignition-switched) and hazard lamps (always live). The hazard switch overrides the turn-signal switch contacts and feeds both sides simultaneously. Switch illumination is tapped off the 'illumination system' bus so the hazard button glows with the side lights.
Wiring Schematic
Components (19)
Connections (20)
BAT
BATFB10A_bHazard battery feed (always live)
IGN
IGNFB10A_aTurn-signal feed (ignition-switched)
FB10A_a
FB10A_aCFUGreen — flasher unit power
FB10A_b
FB10A_bHSWGreen with White — hazard battery feed
HSW
HSWCFUGreen with Red — hazard tap into flasher
CFU
CFUTSWLight Green with Black — flasher output to turn switch
TSW
TSWFRT_RHGreen with Yellow — RH turn signal feed (R contact)
TSWREAR_RHGreen with Yellow — RH rear turn
TSWMET_RHGreen with Yellow — RH tell-tale
TSWSID_RHGreen with Yellow — RH side repeater
TSWFRT_LHGreen with Black — LH turn signal feed (L contact)
TSWREAR_LHGreen with Black — LH rear turn
TSWMET_LHGreen with Black — LH tell-tale
TSWSID_LHGreen with Black — LH side repeater
FRT_RH
FRT_RHGND_RHBlack — RH front turn ground
FRT_LH
FRT_LHGND_LHBlack — LH front turn ground
REAR_RH
REAR_RHGND_METERBlack — RH rear turn ground
REAR_LH
REAR_LHGND_METERBlack — LH rear turn ground
SID_RH
SID_RHGND_RHBlack — RH side repeater ground
SID_LH
SID_LHGND_LHBlack — LH side repeater ground
See also
Foldout page (S.M.J.)