COMBINATION SWITCH — Operational Check — LHD Models (Supplement-VII)
EL-7011component photoLHD combination switch operational check. MIST mode + REAR WIPE + FRONT/REAR washer pump direction all present — same set as Supplement-VI. RHD pendant follows on subsequent pages.
Operational Check — LHD Models
Left
FunctionLIGHT
PositionsMAIN BEAM (A) / DIP (B) / MAIN BEAM FLASH (C); rotate ring: 1ST / 2ND
Left
FunctionFOG LAMP
PositionsFRONT AND REAR / FRONT / OFF
Left
FunctionTURN
PositionsR / N / L (right / neutral / left)
Right
FunctionREAR WIPER
PositionsOFF / WIPE
Right
FunctionFRONT WIPER
PositionsMIST / OFF / INT / LO / HI
Right
FunctionWASHER
PositionsREAR / OFF / FRONT
NOTE
Combination-switch layout for LHD models. Three sub-connector blocks on the switch body:
• LIGHTING, FOG LAMP AND TURN SIGNAL SWITCH — 12-pin (left stalk)
• WIPER AND WASHER SWITCH — 8-pin (right stalk primary)
• WIPER AND WASHER SWITCH (secondary block) — 2-pin (pin 20 / pin 1)
Pins FF + RF on the lighting block are dedicated FRONT FOG and REAR FOG outputs respectively.
Note: FRONT WIPER MIST position (push stalk away from driver) is now standard in Supplement-VII trim — momentary single-wipe. INT is the intermittent mode.
Continuity tables for each switch position are on the following page (EL-7012).