DTC P0335 CRANKSHAFT POSITION SENSOR (POS) - Diagnostic Procedure (Cont'd)
EF & EC-7179flowchartCG10, CGA3
Diagnostic Procedure (Cont'd)
Diagnostic Procedure - Steps 2 to 5
1
2. CHECK POWER SUPPLY: 1. Disconnect crankshaft position sensor (POS) harness connector. 2. Turn ignition switch "ON". 3. Check voltage between crankshaft position sensor (POS) terminal 1 and ground with CONSULT-II or tester. Voltage: Battery voltage
2
OK or NG
NG
Repair or replace harness or connectors.
OK (GO TO 4)
3
3. CHECK GROUND CIRCUIT: 1. Disconnect ECM harness connector. 2. Check continuity between ECM terminal 43 and crankshaft position sensor (POS) harness connector terminal 2. Refer to wiring diagram. Continuity should exist. 3. Also check harness for short to power.
4
OK or NG
NG
Repair open circuit or short to ground or short to power in harness or connectors.
OK (GO TO 4)
5
4. CHECK CRANKSHAFT POSITION SENSOR (POS): Refer to "Component Inspection", EC-7180.
6
OK or NG
NG
Replace crankshaft position sensor (POS).
OK (GO TO 5)
7
5. CHECK INTERMITTENT INCIDENT: Perform "TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT", EC-7070.
INSPECTION END
See also
EC-7180 · EC-7070