ON BOARD DIAGNOSTIC SYSTEM DESCRIPTION — CONSULT-II (Cont'd); Data Monitor Mode (continued)
EF & EC-7043spec tableCONSULT-II (Cont'd)
CG10, CGA3
Data Monitor Mode (continued)
HO2S1 MNTR (B1) [RICH/LEAN]
ECM input signals○
Main signals○
Description- Display of heated oxygen sensor 1 (front) signal during air-fuel ratio feedback control:
RICH ... means the mixture became "rich", and control is being affected toward a leaner mixture.
LEAN ... means the mixture became "lean", and control is being affected toward a rich mixture.
Remarks- After turning ON the ignition switch, "RICH" is displayed until air-fuel mixture ratio feedback control begins.
- When the air-fuel ratio feedback is clamped, the value just before the clamping is displayed continuously.
VHCL SPEED SE [km/h] or [mph]
ECM input signals○
Main signals○
Description- The vehicle speed computed from the vehicle speed sensor signal is displayed.
Remarks
BATTERY VOLT [V]
ECM input signals○
Main signals○
Description- The power supply voltage of ECM is displayed.
Remarks
THRTL POS SEN [V]
ECM input signals○
Main signals○
Description- The throttle position sensor signal voltage is displayed.
Remarks
INT/A TEMP SE [°C] or [°F]
ECM input signals○
Main signals
Description- The intake air temperature determined by the signal voltage of the intake air temperature sensor is indicated.
Remarks
START SIGNAL [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates [ON/OFF] condition from the starter signal.
Remarks- After starting the engine, [OFF] is displayed regardless of the starter signal.
CLSD THL POS [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates idle position [ON/OFF] computed by ECM according to the throttle position sensor signal.
Remarks
AIR COND SIG [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates [ON/OFF] condition of the air conditioner switch as determined by the air conditioning signal.
Remarks
P/N POSI SW [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates [ON/OFF] condition from the PNP switch signal.
Remarks
PW/ST SIGNAL [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates [ON/OFF] condition of the power steering oil pressure switch determined by the power steering oil pressure switch signal.
Remarks
LOAD SIGNAL [ON/OFF]
ECM input signals○
Main signals○
Description- Indicates [ON/OFF] condition from the electrical load signal and/or lighting switch.
ON ... rear defogger is operating and/or lighting switch is on.
OFF ... rear defogger is not operating and lighting switch is not on.
Remarks
IGNITION SW [ON/OFF]
ECM input signals○
Main signals
Description- Indicates [ON/OFF] condition from ignition switch.
Remarks
HEATER FAN SW [ON/OFF]
ECM input signals○
Main signals
Description- Indicates [ON/OFF] condition from the heater fan switch.
Remarks
INJ PULSE -B1 [msec]
ECM input signals
Main signals○
Description- Indicates the actual fuel injection pulse width compensated by ECM according to the input signals.
Remarks- When the engine is stopped, a certain computed value is indicated.
IGN TIMING [BTDC]
ECM input signals
Main signals○
Description- Indicates the ignition timing computed by ECM according to the input signals.
Remarks
IACV-AAC/V [%]
ECM input signals
Main signals○
Description- Indicates the IACV-AAC valve control value computed by ECM according to the input signals.
Remarks