Diagnostic Procedure 16 — Engine stalls when the Electrical Load is Heavy (Cont'd)
EF & EC-107flowchartDiagnostic Procedure 16 — Engine stalls when the Electrical Load is Heavy (Cont'd)
1
B (from previous page)
2
Check spark plugs. Remove spark plugs from engine and check for contaminants, damage and proper spark plug gaps.
N.G.
Repair or replace.
O.K.
3
Conduct power balance test. [CONSULT] Start engine. Conduct 'POWER BALANCE' test with 'ACTIVE TEST' showing on display. Test must be finished as quickly as possible. Do not conduct test while vehicle is being driven. Check to ensure idle speed momentarily decreases while testing each cylinder. [No CONSULT] Start engine. Check to ensure idle speed momentarily decreases when each injector connector is removed from cylinder.
O.K.
4
Check injectors. Stop engine. Remove distributor. (Do not remove crank angle sensor harness connector.) Remove power transistor connector. Turn ignition switch to 'ON'. Check to ensure each injector emits hissing sound when crankshaft is hand-rotated. Display shows an erratic indication during self-diagnosis and does not show abnormalities.
N.G.
Check injectors and circuits. Refer to 'Injector'. (See page EF&EC-153)
O.K.
5
C (continues to next page)