TROUBLE DIAGNOSES — Diagnostic Procedure 26 (Cont'd)
EF & EC-142flowchartDiagnostic Procedure 26 (Cont'd)
Diagnostic Procedure 26 (ignition signal) — component check
1
A (continued from previous page)
2
CHECK COMPONENTS (Ignition coil, resistor and power transistor). Refer to "Electrical Components Inspection". (See pages EF&EC 171 - 180)
N.G.
Replace malfunctioning component(s).
O.K.
Check E.C.U. pin terminals for damage or poor connection of E.C.U. harness connector.
Perform FINAL CHECK by the following procedure after repair is completed.
Final Check
1
FINAL CHECK
2
Erase the self-diagnosis memory.
3
Perform test drive.
4
Perform self-diagnosis again.
N.G.
Recheck E.C.U. pin terminals for damage or the connection of E.C.U. harness connector.
O.K.
INSPECTION END
See also
EF & EC 171 - 180