DTC P1758 LINE PRESSURE CONTROL SOLENOID VALVE CIRCUIT
AT-7091spec tableDescription
Line pressure is controlled by a signal sent from TCM to generate the line pressure necessary for torque transmission by steel belt. The pressure is returned from the line pressure sensor to TCM, and it is regulated continuously to maintain the target oil pressure.
CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE
NOTE
Remarks: Specification data are reference values.
CONSULT-II reference values — line pressure solenoid
LINE PRES SOL
ConditionVehicle being driven
SpecificationApprox. 0 - 1.0A
*LINE PRES SOL
ConditionVehicle being driven
SpecificationApprox. 0 - 1.0A
TCM TERMINALS AND REFERENCE VALUE
NOTE
Remarks: Specification data are reference values.
TCM terminals — line pressure control solenoid valve
6
Wire colorW/G
ItemLine pressure control solenoid valve
ConditionIgnition switch ON, engine running. "D" positions, and accelerator pedal and brake pedal released after driving.
Judgement standard (Approx.)4 - 6V
ON BOARD DIAGNOSIS LOGIC
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
CAUTION
Always drive vehicle at a safe speed.
NOTE
If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
After the repair, perform the following procedure to confirm that the malfunction is eliminated.
With CONSULT-II
DTC P1758 confirmation procedure (With CONSULT-II)
- 1Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II. If the check result is NG, go to "Diagnostic Procedure", AT-7094.
SAT651J