DTC P0715 INPUT PULLEY SPEED SENSOR
AT-7062prose procedureDescription
NOTE
The input pulley speed sensor detects the input pulley revolution speed and sends a signal to the ECM.
TCM TERMINALS AND REFERENCE VALUE
NOTE
Remarks: Specification data are reference values.
44
Wire colorPU/R
ItemInput pulley speed sensor
ConditionWhen driving (D position, 20 km/h), the pulse measurement by using the pulse measurement function of CONSULT-III.
Judgement standard (Approx.)870 Hz
ON BOARD DIAGNOSIS LOGIC
IN PY SPD SEN/CIRC; P0715; MI Code No. 0715
Malfunction is detected when ...TCM does not receive the proper voltage signal from the sensor.
Check items (Possible cause)Harness or connectors (The sensor circuit is open or shorted.); Input pulley speed sensor
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
CAUTION
Always drive vehicle at a safe speed. Be careful not to rev engine into the red zone on the tachometer.
NOTE
If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
NOTE
After the repair, perform the following procedure to confirm the malfunction is eliminated.
With CONSULT-II
- 1Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
SAT651J - 2Start engine and maintain the following conditions for at least 6 consecutive seconds. O/P PULLY SIG: 10 km/h (6 MPH) or more; THRTL POS SEN: More than 0.7 - 0.8V; Selector lever: D position; ENG SPEED: 500 rpm or more; Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. If the check result is NG, go to "Diagnostic Procedure", AT-7064.
With GST
NOTE
Follow the procedure "With CONSULT-II".