DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH
AT-7052prose procedureDescription (Cont'd)
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
CAUTION
Always drive vehicle at a safe speed.
NOTE
If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
NOTE
After the repair, perform the following procedure to confirm the malfunction is eliminated.
With CONSULT-II
- 1Turn ignition switch "ON".
SAT651J - 2Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
654J - 3Start engine and maintain the following conditions for at least 15 consecutive seconds. O/P PULLY SIG: 10 km/h (6 MPH) or more; THRTL POS SEN: More than 0.7 - 0.8V; Selector lever: D position; ENG SPEED: 500 rpm or more. If the check result is "NG", go to "Diagnostic Procedure", AT-7054.
With GST
NOTE
Follow the procedure "With CONSULT-II".