DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH - Component Inspection

AT-7056prose procedure

Component Inspection

1
Check continuity between terminals between terminals 3 and 2, 6, 5, 1, 4 while moving manual shaft through each position.
2
If NG, check again with control cable disconnected from manual shaft of CVT assembly. Refer to step 1.
3
If OK on step 2, adjust control cable. Refer to AT-7121.
4
If NG on step 2, remove PNP switch from CVT and check continuity of PNP switch terminals. Refer to step 1.
5
If OK on step 4, adjust PNP switch. Refer to AT-7121.
6
If NG on step 4, replace PNP switch.

Terminal No.3 - 2

Terminal No.3 - 6

Terminal No.3 - 5

Terminal No.3 - 1

Terminal No.3 - 4