DTC P0705 PARK/NEUTRAL POSITION (PNP) SWITCH
AT-7055flowchartDiagnostic Procedure (Cont'd)
DTC P0705 PNP switch diagnostic flow (steps 2-3)
1
CHECK PNP SWITCH CIRCUIT (Without CONSULT-II)
2
OK or NG
NG
Check the following items: PNP switch (Refer to "Component Inspection", AT-7056). Harness for short or open between ignition switch and PNP switch (Main harness). Harness for short or open between PNP switch and TCM (Main harness). Ignition switch and 10A fuse (Refer to EL section "POWER SUPPLY ROUTING"). Diode (P, N positions).
Check the following items: PNP switch (Refer to "Component Inspection", AT-7056). Harness for short or open between ignition switch and PNP switch (Main harness). Harness for short or open between PNP switch and TCM (Main harness). Ignition switch and 10A fuse (Refer to EL section "POWER SUPPLY ROUTING"). Diode (P, N positions).
OK / GO TO 3
3
GO TO 3.
4
CHECK DTC
5
OK or NG
NG
1. Perform TCM input/output signal inspection. 2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK
INSPECTION END
PNP switch voltage check matrix (B=Battery voltage, 0=0V)
P
Terminal 32B
Terminal 410
Terminal 330
Terminal 480
Terminal 470
N
Terminal 320
Terminal 410
Terminal 330
Terminal 480
Terminal 47B
R
Terminal 320
Terminal 41B
Terminal 330
Terminal 480
Terminal 470
D
Terminal 320
Terminal 410
Terminal 33B
Terminal 480
Terminal 470
L
Terminal 320
Terminal 410
Terminal 330
Terminal 48B
Terminal 470