DTC P0715 INPUT PULLEY SPEED SENSOR

AT-7062spec table

Description

The input pulley speed sensor detects the input pulley revolution speed and sends a signal to the ECM.

TCM TERMINALS AND REFERENCE VALUE

NOTE

Remarks: Specification data are reference values.

TCM terminals — input pulley speed sensor

Terminal No.	Wire color	Item	Condition	Judgement standard (Approx.)
44	PU/R	Input pulley speed sensor	When driving [D position, 20 km/h (12 MPH)], the pulse measurement by using the pulse measurement function of CONSULT-III.	870 Hz

Wire colorPU/R

ItemInput pulley speed sensor

ConditionWhen driving [D position, 20 km/h (12 MPH)], the pulse measurement by using the pulse measurement function of CONSULT-III.

Judgement standard (Approx.)870 Hz

ON BOARD DIAGNOSIS LOGIC

Code P0715

IN PY SPD SEN/CIRC

Possible Causes

Harness or connectors (The sensor circuit is open or shorted.)
Input pulley speed sensor

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION

Always drive vehicle at a safe speed. Be careful not to rev engine into the red zone on the tachometer.

NOTE

If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II

DTC P0715 confirmation procedure (With CONSULT-II)

1
Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
SAT651J
2
Start engine and maintain the following conditions for at least 6 consecutive seconds. O/P PULLY SIG: 10 km/h (6 MPH) or more. THRTL POS SEN: More than 0.7 - 0.8V. Selector lever: D position. ENG SPEED: 500 rpm or more. Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. If the check result is NG, go to "Diagnostic Procedure", AT-7064.

With GST

Follow the procedure "With CONSULT-II".

Support our work!