DTC P1751 SHIFT CONTROL SOLENOID VALVE FUNCTION
AT-7080spec tableDescription
Shift control pressure is controlled by a signal sent from TCM to regulate shift change by steel belt.
CONSULT-II REFERENCE VALUE IN DATA MONITOR MODE
NOTE
Remarks: Specification data are reference values.
CONSULT-II reference values — shift control solenoid
SH CONT SOL
ConditionVehicle is being driven.
SpecificationApprox. 0 - 1.0A
*SH CONT SOL
ConditionVehicle is being driven.
SpecificationApprox. 0 - 1.0A
TCM TERMINALS AND REFERENCE VALUE
NOTE
Remarks: Specification data are reference values.
TCM terminals — shift control solenoid valve
5
Wire colorL/W
ItemShift control solenoid valve
ConditionIgnition switch ON, engine running. "D" position, and accelerator pedal and brake pedal released after driving.
Judgement standard (Approx.)3 - 5V
ON BOARD DIAGNOSIS LOGIC
DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE
CAUTION
Always drive vehicle at a safe speed.
NOTE
If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.
After the repair, perform the following procedure to confirm that the malfunction is eliminated.
With CONSULT-II
DTC P1751 confirmation procedure (With CONSULT-II)
- 1Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
SAT651J - 2Start engine and maintain the following conditions for at least 5 consecutive seconds. O/P PULLY SIG: 10 km/h (6 MPH) or more. THRTL POS SEN: More than 0.7 - 0.8V. Selector lever: D position. ENG SPEED: 500 rpm or more. FLUID TEMP SEN: 20 - 99°C (68 - 210°F). If the check result is NG, go to "Diagnostic Procedure", AT-7085.