DTC P0715 INPUT PULLEY SPEED SENSOR
AT-7064flowchartDiagnostic Procedure
DTC P0715 input pulley speed sensor diagnostic flow
1
CHECK INPUT PULLEY SPEED SENSOR
2
OK or NG
OK (Without CONSULT-II) / GO TO 3
GO TO 3.
NG
Repair or replace input pulley speed sensor.
OK (With CONSULT-II) / GO TO 2
3
GO TO 2.
4
CHECK INPUT SIGNAL (With CONSULT-II)
5
OK or NG
NG
Check the following items: Harness for short or open between TCM and input pulley speed sensor (Main harness). Harness for short or open between TCM and ignition switch (Main harness). Ignition switch and 10A fuse (Refer to EL section "POWER SUPPLY ROUTING"). Ground circuit.
Check the following items: Harness for short or open between TCM and input pulley speed sensor (Main harness). Harness for short or open between TCM and ignition switch (Main harness). Ignition switch and 10A fuse (Refer to EL section "POWER SUPPLY ROUTING"). Ground circuit.
OK / GO TO 3
6
GO TO 3.
7
CHECK DTC
8
OK or NG
NG
1. Perform TCM input/output signal inspection. 2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK
INSPECTION END