DTC P0710, P0711 CVT FLUID TEMPERATURE SENSOR CIRCUIT

AT-7058prose procedure

Description (Cont'd)

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION

Always drive vehicle at a safe speed.

NOTE

If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

With CONSULT-II

DTC P0710/P0711 confirmation procedure (With CONSULT-II)

1
Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
SAT651J
2
Start engine and maintain the following conditions for at least 10 minutes (Total). (It is not necessary to maintain continuously.) ENG SPEED: 500 rpm or more. O/P PULLY SIG: 10 km/h (6 MPH) or more. THRTL POS SEN: More than 0.7 - 0.8V. Selector lever: D position. If the check result is NG, go to "Diagnostic Procedure", AT-7060.

With GST

Follow the procedure "With CONSULT-II".

Support our work!