DTC P1756 LINE PRESSURE CONTROL SENSOR FUNCTION

AT-7087prose procedure

Description (Cont'd)

DIAGNOSTIC TROUBLE CODE (DTC) CONFIRMATION PROCEDURE

CAUTION

Always drive vehicle at a safe speed.

NOTE

If "DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch "OFF" and wait at least 5 seconds before conducting the next test.

After the repair, perform the following procedure to confirm that the malfunction is eliminated.

With CONSULT-II

DTC P1756 confirmation procedure (With CONSULT-II)

1
Turn ignition switch "ON" and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
SAT651J
2
Start engine and maintain the following conditions for at least 5 consecutive seconds. O/P PULLY SIG: 10 km/h (6 MPH) or more. THRTL POS SEN: More than 0.7 - 0.8V. Selector lever: D position. ENG SPEED: 500 rpm or more. FLUID TEMP SE: 20 - 99°C (68 - 210°F). If the check result is NG (P1758), go to "Diagnostic Procedure", AT-7094. If the check result is NG (P1756), go to "Diagnostic Procedure", AT-7089.

With GST

Follow the procedures under "With CONSULT-II".

Support our work!