TROUBLE DIAGNOSIS — GENERAL DESCRIPTION - TCM Terminals and Reference Value (Cont'd)
AT-7047spec tableTCM Terminals and Reference Value (Cont'd)
TCM Inspection Table (continued)
41
Wire colorG/W
ItemPNP switch "R" position
ConditionWhen setting selector lever to "R" position. (Ignition ON)
Judgement standard (Approx.)12V
41
Wire colorG/W
ItemPNP switch "R" position
ConditionWhen setting selector lever to other positions. (Ignition ON)
Judgement standard (Approx.)0V
42
Wire colorOR/L
ItemSports mode switch
ConditionWhen SPORT mode switch is in "ON" position. (Engine running)
Judgement standard (Approx.)0V
42
Wire colorOR/L
ItemSports mode switch
ConditionWhen SPORT mode switch is in "OFF" position. (Engine running)
Judgement standard (Approx.)Battery voltage
43
Wire colorW/B
ItemCVT fluid pressure sensor / CVT fluid temperature sensor (Ground)
Condition—
Judgement standard (Approx.)—
44
Wire colorPU/R
ItemInput pulley speed sensor
ConditionWhen driving (D position, 20 km/h), the pulse measured by using the pulse measurement function of CONSULT-II. CONSULT-II cable connected to the data link connector. This inspection cannot be measured by the circuit tester.
Judgement standard (Approx.)870 Hz
45
Wire colorPU/W
ItemOutput pulley speed sensor
ConditionWhen driving (D position, 20 km/h), the pulse measured by using the pulse measurement function of CONSULT-II. CONSULT-II cable connected to the data link connector. This inspection cannot be measured by the circuit tester.
Judgement standard (Approx.)330 Hz
47
Wire colorL/R
ItemPNP switch "N" position
ConditionWhen setting selector lever to "N" position. (Ignition ON)
Judgement standard (Approx.)Battery voltage
47
Wire colorL/R
ItemPNP switch "N" position
ConditionWhen setting selector lever to other positions. (Ignition ON)
Judgement standard (Approx.)0V
48
Wire colorL
ItemPNP switch "L" position
ConditionWhen setting selector lever to "L" position. (Ignition ON)
Judgement standard (Approx.)Battery voltage
48
Wire colorL
ItemPNP switch "L" position
ConditionWhen setting selector lever to other positions. (Ignition ON)
Judgement standard (Approx.)0V
NOTE
*1: This terminal is connected to the ECM.
*2: These terminals are connected to the Data link connector for CONSULT-II.