REPAIR FOR COMPONENT PARTS — Input Shaft and Gears (Cont'd) (RS5F30A & RS5F31V)
MT-42prose procedurePage applies to RS5F30A and RS5F31V transaxle variants. Assembly procedure continues on MT-43.
Input Shaft and Gears (Cont'd)
INSPECTION
Gear and shaft
NOTE
Check shaft for cracks, wear or bending.
Check gears for excessive wear, chips or cracks.
Synchronizer
NOTE
Check spline portion of coupling sleeves, hubs and gears for wear of cracks.
Check baulk rings for cracks or deformation.
Check shifting inserts for wear or deformation.
Measure clearance between baulk ring and gear.
| Specification | Value |
|---|---|
| Clearance between baulk ring and gear — Standard | 1.0 - 1.35mm (0.0394 - 0.0531 in) |
| Clearance between baulk ring and gear — Wear limit | 0.7mm (0.028 in) |
Clearance between baulk ring and gear — Standard
1.0 - 1.35mm (0.0394 - 0.0531 in)
Clearance between baulk ring and gear — Wear limit
0.7mm (0.028 in)
Bearing
NOTE
Make sure bearings roll freely and are free from noise, cracks, pitting or wear.
ASSEMBLY
Input shaft assembly
- 1Assemble 5th synchronizer.
SMT736A