SUPPLEMENTAL RESTRAINT SYSTEM (SRS) — Precautions for SRS "Air Bag" & Special Service Tools

Do not use a circuit tester to check SRS circuits unless instructed to in this Service Manual. Before servicing the SRS, turn ignition switch "OFF", disconnect both battery cables and wait at least 3 minutes. For approximately 3 minutes after the cables are removed, it is still possible for the air bag to deploy. Therefore, do not work on any SRS connectors or wires until at least 3 minutes have passed. Diagnosis sensor unit must always be installed with their arrow marks "⇧" pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required. The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear. Handle air bag module carefully. Always place it with the pad side facing upward. Conduct self-diagnosis to check entire SRS for proper function after replacing any components. After passenger air bag inflates, the front instrument panel assembly should be replaced if damaged.