SUPPLEMENTAL RESTRAINT SYSTEM (SRS) — Precautions for SRS "AIR BAG" Services

Do not use a circuit tester to check SRS circuits. Before servicing the SRS, turn ignition switch "OFF", disconnect battery ground cable and wait for at least 10 minutes. For approximately ten minutes after the cables are removed, it is still possible for the air bag to inflate. Therefore, do not work on any air bag system connectors or wires until at least ten minutes have passed. Check Diagnosis sensor unit for cracks, deformities or rust before installation, and replace as required. The spiral cable must be aligned with the neutral position since its rotations are limited. Do not attempt to turn steering wheel or column after removal of steering gear. Handle air bag module carefully. Always place it with the pad side facing upward. After removing any SRS parts, discard old special bolts and replace with new ones. Conduct self diagnosis to check entire SRS for proper function. Do not service the air bag module when seated directly in front of it. Always work from the side.