BODY ALIGNMENT — Engine Compartment (Cont'd) — Measurement Points
BF-53component photoThe 'f' lower-case point on fig4 is shown with a 15 mm dia hole — different from the 8 mm dia hole at the upper-case 'F' point in fig2. They are different points (asymmetric), not a simple LH/RH mirror.
Engine Compartment (Cont'd) — Measurement Points
NOTE
Reference holes for the BF-52 alignment measurements, with hole diameters in mm. Each photo shows where the measurement-point arrow is meant to land on the actual body shell.
A
LocationCowl center top
Hole dia. (mm)5
B
LocationStrut tower
Hole dia. (mm)8
C
LocationStrut tower
Hole dia. (mm)10
D
LocationRadiator side support
Hole dia. (mm)8
E
LocationRadiator side support
Hole dia. (mm)8
F
LocationSide member
Hole dia. (mm)8
G
LocationRadiator support
Hole dia. (mm)8
H
LocationRadiator support
Hole dia. (mm)8
I
LocationRadiator support
Hole dia. (mm)16
J
LocationRadiator side support
Hole dia. (mm)8
f (lower-case)
LocationSide member (mirror of F)
Hole dia. (mm)15