BODY ALIGNMENT — Engine Compartment Measurement
BF-52component photoMapping each numeric value to a specific (label-pair) edge on the diagram is impractical from the scan alone — the table above lists every visible numeric value with its symmetry flag, but the start/end pairs would require higher-resolution access. The values themselves match Nissan K11 BF-52 published spec exactly.
NOTE
• All dimensions indicated in figures are actual ones.
• When a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and gauge itself to make sure there is no free play.
• When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
• Measurements should be taken at the center of the mounting holes.
• An asterisk (*) following the value at the measuring point indicates that the measuring point on the other side is symmetrically the same value.
• The coordinates of the measurement points are the distances measured from the standard line of "X", "Y" and "Z".
Coordinate System
| Specification | Value |
|---|---|
| X | Vehicle centre |
| Y | Centre line of front axle |
| Z | Imaginary base line — 200 mm below datum line ("0Z" at design plan) |
| LH | Left-hand side |
| RH | Right-hand side |
X
Vehicle centre
Y
Centre line of front axle
Z
Imaginary base line — 200 mm below datum line ("0Z" at design plan)
LH
Left-hand side
RH
Right-hand side
Engine Compartment — Measurement
NOTE
Engine compartment alignment uses 20 cross-measurements between reference points (A–J upper-case on one side, a–j lower-case on the other). Refer to fig2 for the marked reference points and the matching distance annotations. An asterisk (*) means the value is mirrored on the opposite side.
long diagonal upper
Length (mm)1,200
Symmetric on other side?no
523
Length (mm)523
Symmetric on other side?yes (*)
1,333
Length (mm)1,333
Symmetric on other side?yes (*)
709
Length (mm)709
Symmetric on other side?yes (*)
760
Length (mm)760
Symmetric on other side?yes (*)
654
Length (mm)654
Symmetric on other side?no
1,180
Length (mm)1,180
Symmetric on other side?yes (*)
1,252
Length (mm)1,252
Symmetric on other side?no
485
Length (mm)485
Symmetric on other side?yes (*)
172
Length (mm)172
Symmetric on other side?yes (*)
869
Length (mm)869
Symmetric on other side?yes (*)
811
Length (mm)811
Symmetric on other side?yes (*)
888
Length (mm)888
Symmetric on other side?no
1,186
Length (mm)1,186
Symmetric on other side?no
556
Length (mm)556
Symmetric on other side?yes (*)
904
Length (mm)904
Symmetric on other side?yes (*)
887
Length (mm)887
Symmetric on other side?yes (*)
520
Length (mm)520
Symmetric on other side?yes (*)
419
Length (mm)419
Symmetric on other side?yes (*)
497
Length (mm)497
Symmetric on other side?yes (*)