SUNROOF — Adjustment
BF-45prose procedureSunroof lid must sit 0-1 mm above or flush with the roof panel along section A-A; the weatherstrip should engage the glass by 6-7 mm. Lid linkage has two motion ranges — slide (Closing & opening) and tilt (Tilting up & down) — independent of each other.
ADJUSTMENT
NOTE
When sunroof rail assembly are being installed, perform operations in the following sequence:
Sunroof rail assembly — installation sequence
- 1Make sure that link and wire assemblies are in the same symmetric position on both sides.
- 2Fit outer side of lid assembly to the surface of roof on body outer panel.
| Specification | Value |
|---|---|
| Glass-lid flushness to roof panel | 0 - 1mm |
| Weatherstrip-to-glass engagement | 6 - 7mm |
Glass-lid flushness to roof panel
0 - 1mm
Weatherstrip-to-glass engagement
6 - 7mm