TROUBLE DIAGNOSES FOR SYMPTOMS — Diagnostic Procedure 11 (ABS Warning lamp does not come on when ignition switch is turned ON) (Cont'd)
BR-7046flowchartTerminal *1 differs: pin 10 on MT models, pin 21 on CVT models.
Diagnostic Procedure 11 (ABS Warning lamp does not come on when ignition switch is turned ON) (Cont'd)
Diagnostic Procedure 11 — branch A
1
(A) — Continued from previous page
2
B — CHECK WARNING LAMP INDICATION.
Disconnect ABS actuator and electric unit connector.
Does the warning lamp activate?
No
(B) (See below)
Yes
3
CHECK HARNESS CONNECTOR.
Check ABS actuator and electric unit pin terminals for damage or the connection of ABS actuator and electric unit harness connector.
Reconnect ABS actuator and electric unit harness connector. Then retest
NG
REPLACE.
REPLACE.
Replace ABS actuator and electric unit.
OK
Inspection end.
Diagnostic Procedure 11 — branch B
1
(B) — Continued from above
2
C — CHECK HARNESS FOR SHORT.
1. Disconnect ABS actuator and electric unit connector.
2. Check voltage between ABS actuator and electric unit connector (E96) (body side) terminal 10, 21, and ground.
Battery voltage should not exist.
NG
Repair harness or connector between fuse and ABS actuator and electric unit connector terminal.
OK
3
CHECK COMBINATION METER.
Check combination meter. Refer to WARNING LAMPS in EL section.