TROUBLE DIAGNOSES — Diagnostic Procedure 4 (Cont'd) — N-CVT I/O Signal & Circuit (L.E.D. flashing number 10)
BR-65flowchartContinuity check uses different terminal pairs depending on whether the car has N-CVT (3-45) or not (36-45) — the manual transaxle and CVT variants share the connector but route different signals through 36 / 3.
Diagnostic Procedure 4 (Cont'd)
N-CVT I/O SIGNAL & CIRCUIT (L.E.D. flashing number 10)
1
A — CHECK N-CVT I/O SIGNAL & CIRCUIT. Remove connectors of ABS Control Unit. Check continuity between terminals: 3-45 (with N-CVT) 0 Ω; 36-45 (w/o N-CVT) 0 Ω.
N.G.
Repair harness.
O.K.
2
B — Turn ignition switch ON. Check voltage between terminal ㉜ of body harness and body ground. Voltage: approx. 12V.
N.G.
Check N-CVT and ECCS circuit.
O.K.
3
Perform "STOPLAMP-SWITCH CIRCUIT" check.