MASTER CYLINDER (NABCO)
BR-7007parts diagramProcedure differs between LHD and RHD: LHD requires removing air cleaner and repositioning fuel filter bracket.
Parts DiagramFig. fig1
| Specification | Value |
|---|---|
| Reservoir tank mounting fastenerTightening torque | 12 - 15N·m |
Reservoir tank mounting fastenerTightening torque
12 - 15N·m
NOTE
Legend: ⊗ Do not re-use, ░ Silicon grease, ▲ Brake fluid point, N·m (kg-m, ft-lb).
Removal
CAUTION
Be careful not to splash brake fluid on painted areas; it may cause paint damage. If brake fluid is splashed on painted areas, wash it away with water immediately.
Master Cylinder Removal
- 1Remove air cleaner (LHD only).
- 2Disconnect low fluid warning light harness.
- 3Connect a vinyl tube to air bleeder valve.
- 4Drain brake fluid from each air bleeder valve, depressing brake pedal to empty fluid from master cylinder.
- 5Remove brake pipe flare nuts from master cylinder.
- 6Remove master cylinder mounting nuts.
UBR048 - 7Reposition fuel filter bracket (LHD only).
- 8When removing master cylinder from booster, block hole into booster to prevent ingress of dirt, etc.