TROUBLE DIAGNOSES — CONSULT-II Inspection Procedure (Cont'd) — DATA MONITOR MODE
BR-7026spec tableCONSULT-II Inspection Procedure (Cont'd)
DATA MONITOR MODE
Data Monitor Mode — Monitor item, condition and specification
FR RH SENSOR / FR LH SENSOR / REAR RH SENSOR / REAR LH SENSOR
CONDITIONDrive vehicle. (Each wheel is rotating.)
SPECIFICATIONWheel speed signal — Almost the same speed as speedometer.
STOP LAMP SW
CONDITIONBrake is depressed.
SPECIFICATIONDepress the pedal: ON; Release the pedal: OFF
FR RH IN SOL / FR RH OUT SOL / FR LH IN SOL / FR LH OUT SOL / RR RH IN SOL / RR RH OUT SOL / RR LH IN SOL / RR LH OUT SOL
CONDITION1. Drive vehicle at speeds over 30 km/h (15 mph) for at least one minute. 2. Engine is running.
SPECIFICATIONOperating conditions for each solenoid valve are indicated. ABS is not operating: OFF
MOTOR RELAY
CONDITION1. Drive vehicle at speeds over 30 km/h (15 mph) for at least one minute. 2. Engine is running.
SPECIFICATIONABS is not operating: OFF; ABS is operating: ON
ACTUATOR RELAY
CONDITIONIgnition switch is set to the "ON" position or engine is running.
SPECIFICATIONIgnition switch in the "ON" position (Engine stops): OFF; Engine running: ON
WARNING LAMP
CONDITIONIgnition switch is set to the "ON" position or engine is running.
SPECIFICATIONWarning lamp is turned on: ON; Warning lamp is turned off: OFF
BATTERY VOLT
CONDITIONIgnition switch is set to the "ON" position or engine is running.
SPECIFICATIONPower supply voltage for control unit