TROUBLE DIAGNOSES FOR SELF-DIAGNOSTIC ITEMS — Diagnostic Procedure 2 (ABS actuator solenoid valve and solenoid valve relay) — Malfunction codes 41/42/45/46/51/52/55/56/63
BR-7036flowchartFig2 label prints 'ABC ACTUATOR' — likely a typo for 'ABS ACTUATOR'. Captured verbatim.
Diagnostic Procedure 2 (ABS actuator solenoid valve and solenoid valve relay) — Malfunction code No. 41, 42, 45, 46, 51, 52, 55, 56, 63
1
CHECK FUSIBLE LINK — Check 40A fusible link. For fusible link layout, refer to POWER SUPPLY ROUTING in EL section.
NG
(A) Go to next page (BR-7037).
OK
2
CHECK FUSE — Check 10A fuse [12]. For fuse layout, refer to POWER SUPPLY ROUTING in EL section.
NG
(B) Go to next page (BR-7037).
OK
3
CHECK CONNECTOR — 1. Disconnect ABS actuator and electric unit connector. Check terminals for damage or loose connection. Then reconnect connector. 2. Carry out self-diagnosis again. Does warning lamp activate again?
No
Inspection end
Yes
4
CHECK ABS ACTUATOR AND ELECTRIC UNIT GROUND CIRCUIT — Refer to ABS ACTUATOR AND ELECTRIC UNIT GROUND in Ground Circuit Check, BR-7032.
NG
Repair harness and connector.
OK
5
A — CHECK SOLENOID VALVE RELAY POWER SUPPLY CIRCUIT. 1. Disconnect ABS actuator and electric unit connector. 2. Check voltage between ABS actuator and electric unit connector (E96) body side terminal 18 and ground. Battery voltage should exist.
NG
Check the following: • Harness connector (E96). • Harness for open or short between ABS actuator and electric unit and fusible link. If NG, repair harness or connector.
Check the following: • Harness connector (E96). • Harness for open or short between ABS actuator and electric unit and fusible link. If NG, repair harness or connector.
OK
6
REPLACE — Replace ABS actuator and electric unit.