TROUBLE DIAGNOSES FOR SYMPTOMS — Diagnostic Procedure 10 (Cont'd) / Diagnostic Procedure 11 (ABS Warning lamp does not come on when ignition switch is turned ON)
BR-7045flowchartTerminal *1 differs: pin 10 on MT models, pin 21 on CVT models.
Diagnostic Procedure 10 (Pedal vibration and noise) (Cont'd)
NOTE
ABS may operate and cause vibration under any of the following conditions.
• Applying brake gradually when shifting or operating clutch.
• Low friction (slippery) road.
• High speed concerning.
• Driving over bumps and pot holes.
• Engine speed is over 5,000 rpm with vehicle stopped.
Diagnostic Procedure 11 (ABS Warning lamp does not come on when ignition switch is turned ON)
Diagnostic Procedure 11 — ABS Warning lamp does not come on
1
CHECK FUSE.
Check 10A fuse [8]. For fuse layout, refer to POWER SUPPLY ROUTING in EL section.
NG
Replace fuse.
OK
2
A — CHECK ABS CONTROL UNIT POWER SUPPLY CIRCUIT.
1. Install 10A fuse.
2. Disconnect ABS actuator and electric unit connector.
3. Check voltage between control unit connector terminal 10, 21 and ground after turning ignition switch "ON".
No
(A) (Go to next page.)
Yes
3
(B) (Go to next page.)