PRECAUTIONS AND PREPARATION
FA-2prose procedureAT vs MT distinction for differential side oil seal protector: KV38105500 (AT) vs KV38106300 (MT).
Precautions
IMPORTANT
When installing each rubber part, final tightening must be carried out under unladen condition* with tires on ground.
*: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.
When removing each suspension part, check wheel alignment and adjust if necessary.
Use Tool when removing or installing brake tubes.
Preparation
SPECIAL SERVICE TOOLS
Special Service Tools
HT72520000
Tool nameBall joint remover
DescriptionRemoving tie-rod outer end and lower ball joint
HT71780000
Tool nameSpring compressor (or commercial equivalent)
DescriptionRemoving and installing coil spring
GG94310000
Tool nameFlare nut torque wrench
DescriptionRemoving and installing brake piping
KV38105500 / KV38106300
Tool nameDifferential side oil seal protector
DescriptionInstalling drive shaft — AT: KV38105500, MT: KV38106300