Nissan Micra K11 silhouetteK11

PRECAUTION

LC-2prose procedure

Liquid Gasket Application Procedure

  1. a
    Before applying liquid gasket, use a scraper to remove all traces of old liquid gasket from mating surface.
  2. b
    Apply a continuous bead of liquid gasket to mating surfaces. (Use Genuine Liquid Gasket or equivalent.)
    Be sure liquid gasket is 4.0 to 5.0 mm (0.157 to 0.197 in) wide (for oil pan).
    Be sure liquid gasket is 2.0 to 3.0 mm (0.079 to 0.118 in) wide (in areas except oil pan).
    Two cross-section views illustrating liquid-gasket bead placement. Left view labelled 'Groove' shows a bead seated inside a sealing groove. Right view labelled 'Bolt hole' shows a bead routed on the inner side of a bolt hole, with an arrow pointing to the 'Inner side'.
    SEM371C
  3. c
    Apply liquid gasket to inner sealing surface around hole perimeter area. (Assembly should be done within 5 minutes after coating.)
  4. d
    Wait at least 30 minutes before refilling engine oil and engine coolant.
Support our work!

Search Manual

Search pages, specs, and procedures